Local Dispensing Solutions Worldwide
applications-banner.jpg

Applications

 
   

Bonding With Cyanoacrylate Application
CA is a very frequently used adhesive in the generic bonding application and it is required in a moisture resistant dispensing system. The TS5622VU Diaphragm valve along with the TS500R controller and TS1258 pressure pot is a perfect system for this application.

 
       
    Domed Logo Badges Application (Doming)
Consumer & business products often display the manufacturer's name on a sticker that is encapsulated underneath a dome of fluid. This is called “Doming” and is commonly used as this adds a better “look and feel” to the product. The TS5622VU-DVD with the TS500R controller and TS1258 pressure pot is a perfect system for this application.
 
       
   

Microdot Adhesive Application
Most medical device manufacturing applications require a dispensing system that can provide a highly repeatable dispensing of UV adhesives. With the unique needle shut off design inside the dispensing tip, the TS5440 Microshot needle valve is a perfect choice for these applications. The TS500R controller is recommended for this valve.

 
       
    Spray Conformal Coating Application
The TS5540 Series spray valve along with the TS500R controller and the TS1258 Pressure Pot is an ideal system to spray conformal coating material on the surface of an assembled printed circuit board to provide protection against moisture, dust and corrosion from extreme environments.
 
 
       
    Gasketing Application
When a high throughput or large shot size is required for gasketing or similar “Form-in-place-gasket” applications, the TS941 Series spool valve along with TS350 controller is the recommended system choice. Whether the fluid is fed from a cartridge or pail pump, the TS941 Series will dispense accurately and consistently through a dispensing nozzle or dispensing tip.

For finer deposit control of sealing material, the TS5322 Series Mini Spool Valve with the TS350 controller is recommended.

 
       
    Dam Writing Application
The TS7000 Series rotary valve along with the TS500R controller is an ideal dispensing system to dispense the “Dam” around the die of an integrated circuit (i.c.) as an alternative method to using the pre-form molded design.
 
 
       
    Plural Component Material Dispensing
Plural component material dispensing is no longer a problem when using a Disposable Material Path valve. When the 2-component material starts to cure, just throw away the valve wetted parts. It takes less than 1 minute to replace new parts.

For low viscosity material, the TS1212 Pinch Tube valve along with the TS350 controller is recommended. For medium to high viscosity material with high repeatability rate requirement, the TS5000DMP valve with the TS500R controller is suitable.

 
       
    Solder Paste Dispensing
Solder paste is the most difficult material to dispense. The TS7000 Series Rotary Valve is designed specifically to dispense solder paste without clogging and separation. Dot size as small as 0.010” (0.254mm) can be dispensed consistently. A majority of automated dispensing systems incorporate the TS7000 Series Valve for solder paste dispensing.
 
       


  Techcon is a brand of

  

   © 2014 Techcon, All rights reserved 

   Privacy PolicyCode of Business ConductTerms & ConditionsSite Map    


 

Visit our other brand sites   

metcalQuant 3D